How to change automatic block machine mold and adjust sesnor location?
1. Take our mold in machine, then put new mold. Install mold box, do not screw up screw and bolts, let mold box could move slightly. Then put a pallet on mold box, then put head mold on pallet, adjust head mold location, screw up head mold screw and bolts.GiantLin whatsapp: +86 15269722300

Notice mold direction: A-head mold, B-mold box all have marks, C is block delivery direction

2. Confirm sensor location

Confirm D1 sensor location: Put one pallet on pallet area (Note: This pallet thickness must same with pallet thickness use in future block production), control machine, let mold box down, when mold box touch pallet, then down 5-10mm and keep pallet can not move forward or backward. Now mold box induction metal upside is D1 sensor location. GiantLin whatsapp: +86 15269722300


4. Confirm A1 sensor location: material trolley front top, higher than metal parts, lower than rubber strip top(A area in below picture). This middle location is A1 sensor location; GiantLin whatsapp: +86 15269722300


7. After all those works, choose manual work model, then produce one mold block, then use rule measure brick height. Then fine adjustment A1,B1,C1,D1 sensor location if find somewhere not exactly. If only brick height not exactly, just adjust B1 sensor location.
Note:
Not change date in PLC touch screen if you not familiar with machine PLC. Not change wires connection when receive machine, wires connection are all correct when we delivery. GiantLin whatsapp: +86 15269722300















