how to connection GiantLin manufacturered hydraulic block machine oil tubes?
Giantlin block machine manufacturer whatsapp: +86 15269722300
First, check have mark or not, if have mark:
Connect oil tube and wires between PLC controller and host brick machine. You can find wires connection drawing in PLC controller. You could also find No. mark in every wires. Giantlin block machine manufacturer whatsapp: +86 15269722300
We will do marks in hydraulic station and oil tubes: (Below is sample)


We may also carve marks on metal parts. See number in hydraulic station, you can also find same numbers in oil tubes, then connection one by one.
After connection all oil tubes, you use manual control model, test if button mark is correct with machine movements, if direction not correct, change A, B location.Giantlin block machine manufacturer whatsapp: +86 15269722300
If no mark: connection one by one, most hydraulic block machine design in order

If oil tubes not produced in order, we should check one by one.Press each buttons, see which coil lamp be lighten on valve, then find the corresponding pipe, connection, just do and try like this, you can also connection oil tubes.
After connection, press buttons, if press go front button, but machine movements go back, just change corresponding valve coil location is ok.















